UET Tag-
top of page

Full View Frameless

The EL 150 Aluminum garage door is a frameless looking glass and aluminum door that is revolutionizing the Los Angeles custom garage door industry. Gd4less Custom Garage Door & Gate were one of the first companies to design, and install these high end contemporary looking custom garage doors.

Sporting a modern, sleek, and stylish look the EL 150 Aluminum consists of usually mirrored or opaque glass panels that are seamlessly attached to a fully aluminum frame. This gives the whole door a thoroughly contemporary and modern look, that is hard to beat, and will add instant curb appeal once fully installed.

GD4Less Guarantee

At gd4less we provide quality craftsmanship that will last for years to come.

Design Options







One Car Design 

One Car Design.jpg

Two Car Design:

Two Car Design.jpg

Glass Options - Opaque


Glass Options - Translucent

Glass Options.jpg

Frame Finishes - Powdered Coat and Anodized

Frame Finishes.jpg

Full View Frameless Specifications

  • Material: 1-3/4" thick extruded 6063-T6 non corrosive commercial-grade

  • Sections: Height of section determined by height of door

  • Top rail width - 4-5/8"

  • Bottom rail width - 4-5/8"

  • Combined intermediate rail widths - 4-1/4"

  • Center stile width - 2-7/8" End stile width- 4-5/8"

  • Section Joints: Standard tongue & groove

  • Assembly: Stiles are through bolted to the rails added rigidity and strength

  • Maximum door width: 18ft            

  • Maximum door height: 14ft.


  • Aluminum is sent through a chemical process that leaves it with an extremely durable anodizing finish


  • Glass Size Capabilities: Three options of glass thickness available 1/8" / 1/4" / 1/2"

  • Standard Options: Clear Tempered / Frosted Tempered / White Laminate

       *specialty glass available upon request to match a style of your home             
          *Please Note: All glass is tempered except for laminated options.

  • Glazing is completed using a butyl tape that adheres the glass to the frame and provides a high quality seal

  • Aluminum retainers are snapped in place with a 1/4" EPDM round foam strip between the glass and aluminum retainer acting as another seal and impact dampener


  • All 2" tracks are 12" or 15" Radius - 14 gauge horizontals with 17 gauge verticals

  • All tracks are mounted with reverse continuous jamb angle

  • Horizontals are reinforced with 13 gauge angle mounted continuous to the length of the horizontal

  • All 3" tracks are 15" Radius - 12 gauge and use is determined by weight of door

  • Options: Low Headroom (0" or 3.5" ), High Lift, Vertical Lift, Follow the Pitch


  • All components are galvanized steel and consist of 14 gauge hinges, 12 gauge top & bottom fixture

  • 2" nylon 10 ball bearing rollers with long-stem for top & bottom fixtures and short-stem for hinges

  • Inside lock included

        *Please Note: 11 gauge components and 3" steel 10 ball bearing rollers will be used when specified.


  • Springs are oil tempered and calibrated per door weight, size and track requirements

  • Standard springs are 10,000 cycle

  • 25k, 50k, 100k cycle springs are available with an additional cost.

  • 12 guage bearing & spring plates

  • 16 gauge torsion tube is standard, 14 gauge, 11 gauge and solid shafts are available and used when specified


  • (2) 22GA 2-1/4" galvanized steel struts come with every door, 3" when specified


Weather Seal

  • 4" bulb type bottom weather-seal is standard, 6" available at additional cost

bottom of page